Many water cutting manufacturers will have the phenomenon of sand pipe plug in the operation process, which is caused by the uncleanness of garnet sand. If the garnet sand cleaning process is not up to the standard, the dust and soil in the sand will tend to solidify into a mass once it is damp, whi Read More

Although garnet sand is a necessary abrasive for sand blasting, its requirements are very high, and the chloride content of garnet sand is an important item. Why? First, let's see what chloride is. Chloride is a salt compound formed by the combination of negatively charged chloride ions and positive Read More

Surface pretreatment is to remove visible and invisible dirt on the material surface. So how do they affect the life of the coating?The influence of dirt on coating life mainly comes from two aspects, one is visible dirt, the other is invisible. The former is mainly the dirt, dust, grease, oil, rust Read More

Garnet is an island-like aluminum (calcium) silicate, which can be divided into two main categories: alumina and calcium oxide. The chemical composition of garnet varies greatly. The general chemical formula is A3B2[SiO4]3, where A represents cations such as divalent calcium, magnesium, iron, and ma Read More

The abrasive hardness required for water cutting is high. But high hardness abrasive is not only garnet, brown aluminum oxide also has high hardness. So why not use brown aluminum oxide in water jet cutting?1.The hardness is too high, not suitable for precision cutting.The hardness of Brown aluminum Read More

Water jet cutting is divided into pure water cutting and water jet sand cutting. Both belong to water jet cutting. What is the difference between the two?1. Different objectsThere is no water jet sand pipe inside the pure water jet machine, which is mainly used for cutting softer and lighter materia Read More